LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2010 >> Cobalt LS, 4D Sedan, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 59 (Audio System) >> Self-diagnostic Function >> Reception level indication (Push and hold 5 sec. FM/AM button) (Except DX model)

Reception level indication (Push and hold 5 sec. FM/AM button) (Except DX model)

WARNING: This page is about a different car, the 2011 Honda Insight and 2010 Honda Insight. However, it is still accessible from the selected car via links, so may be relevant.

This diagnostic screen checks the radio reception level. This level then can be used to diagnose the radio reception quality. The reception level is displayed in decibels (dB).

Preparation: 

  1. Enter the reception level indication mode in the self-diagnostic function. The AM/FM antenna amplifier is on and the character (A) is not displayed in the audio display.
    Fig 1: Screen Display - AM/FM Antenna Reception Level Indication
    G06431809Courtesy of AMERICAN HONDA MOTOR CO., INC.
  2. Tune to the FM radio station you wrote down in preparation using the SEEK button ( ↔↔ ), and note the decibel level of that station.
  3. Press and release the RDM/A.SEL button to turn the AM/FM antenna amplifier off (A is now displayed in the audio display).
  4. Note the decibel level of that station.
  5. Press and release the RDM/A.SEL button to turn the AM/FM antenna amplifier back on (A is not displayed in the audio display).
  6. Press and hold the AM/FM button for more than 5 seconds to enter the AM reception mode.
  7. Tune to the AM radio station you wrote down in preparation using the SEEK button ( ↔↔ ), and note the decibel level of that station.
  8. Press and release the RDM/A.SEL button to turn the antenna amplifier off (A is now displayed in the audio display).
  9. Note the decibel level of that station.
  10. Press and release the RDM/A.SEL button to turn the AM/FM antenna amplifier back on (A is not displayed in the audio display).
  11. Turn the ignition switch to LOCK (0), or audio unit off to exit the test mode.
  12. Compare your results to a known-good vehicle, (make sure it is the same year and trim level) in the same location and direction, and under the same environmental conditions.