LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2010 >> Cobalt LS, 4D Sedan, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 52 (Rear Suspension) >> Damper Replacement >> Inspection

Damper Replacement: Inspection

WARNING: This page is about a different car, the 2011 Honda Insight and 2010 Honda Insight. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the flange nut on the damper shaft end, and set the socket wrench and T-handle on the nut.
  2. Compress the damper unit by hand, and check for smooth operation through a full stroke, both compression and extension. The damper should extend smoothly and constantly when compression is released. If it does not, the gas is leaking and the damper should be replaced.
    Fig 1: Inspecting Damper
    G06430632Courtesy of AMERICAN HONDA MOTOR CO., INC.
  3. Check for oil leaks, abnormal noises, and binding during these tests.
scientia non olet · About LEMON Manuals