LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2010 >> Cobalt LS, 4D Sedan, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 48 (Seats) >> Rear Seat Removal/Installation >> Seat-back

Rear Seat Removal/Installation: Seat-back

WARNING: This page is about a different car, the 2011 Honda Insight and 2010 Honda Insight. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the rear seat cushion.
  2. Remove the center seat belt anchor bolt (A).
    Fig 1: Center Seat Belt Anchor Bolt With Torque Specifications
    G06431142Courtesy of AMERICAN HONDA MOTOR CO., INC.
  3. Remove the bolts and the pivot shaft (A) from the seat-back beam (B), then remove the seat-back (C) both sides.

    Left side 

    Fig 2: Pivot Shaft And Bolts (Left Side) With Torque Specifications
    G06431143Courtesy of AMERICAN HONDA MOTOR CO., INC.

    Right side 

    Fig 3: Pivot Shaft And Bolts (Right Side) With Torque Specifications
    G06431144Courtesy of AMERICAN HONDA MOTOR CO., INC.
  4. Install the seat in the reverse order of removal, and before attaching the rear seat-back, make sure there are no twists or kinks in the seat belts.
scientia non olet · About LEMON Manuals