Rear Suspension Lower Cover Replacement

WARNING: This page is about a different car, the 2011 Honda Insight and 2010 Honda Insight. However, it is still accessible from the selected car via links, so may be relevant.

NOTE:

Take care not to scratch the body.
When prying with a flat-tip screwdriver, wrap it with protective tape to prevent damage.

Remove the screw and the clip, detach the hook (A), then remove the rear suspension lower cover (B).
NOTE: To release the clip, pry up on the center pin at the notch (C).

Fig 1: Identifying Hook, Notch And Rear Suspension Lower Cover
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Install the cover in the reverse order of removal, and note these items:
- If the clip is damaged or stress-whitened, replace it with a new one.
- Push the hook portions into place securely.