LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2010 >> Cobalt LS, 4D Sedan, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 43 (Tire Pressure Monitoring System) >> DTC Troubleshooting >> DTC 83: No VSP Signal

DTC 83: No VSP Signal

WARNING: This page is about a different car, the 2011 Honda Insight and 2010 Honda Insight. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: If DTC 85 stored at the same time as DTC 83, troubleshoot DTC 85 first, then recheck for DTC 83.
  1. Turn the ignition switch to ON (II).
  2. Clear the DTC with the HDS.
  3. Test-drive the vehicle at 7 mph (10 km/h) or more.
  4. Check the speedometer.

    Does the speedometer register speed? 

    YES  -Go to step 5.

    NO  -Update the PCM if it does not have the latest software (see PCM UPDATE ), or substitute a known-good PCM (see SUBSTITUTING THE PCM ), then go to step  1 and recheck. If the PCM was updated and DTCs are not indicated, troubleshooting is complete. If the PCM was substituted and DTCs are not indicated, replace the original PCM (see PCM REPLACEMENT ).

  5. Check the VEHICLE SPEED in the TPMS DATA LIST with the HDS.

    Is the vehicle speed indicated? 

    YES  -The system is OK at this time.

    NO  -Substitute a known-good TPMS control unit (see TPMS CONTROL UNIT REPLACEMENT  ), and recheck.

scientia non olet · About LEMON Manuals