LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2010 >> Cobalt LS, 4D Sedan, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 38 (EVAP System) >> EVAP Canister Purge Valve Replacement

EVAP Canister Purge Valve Replacement

WARNING: This page is about a different car, the 2011 Honda Insight and 2010 Honda Insight. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the MAP sensor 3P connector (A) (see KNOCK SENSOR REPLACEMENT ), the MAF sensor/IAT sensor 5P connector (B) (see MAF SENSOR/IAT SENSOR REPLACEMENT ), and the EVAP canister purge valve connector (C), then remove the harness holder (D).
    Fig 1: MAP Sensor 3P Connector , MAF Sensor/IAT Sensor 5P Connector With EVAP Canister Purge Valve Connector And Bolts With Torque Specifications
    G06429648Courtesy of AMERICAN HONDA MOTOR CO., INC.
  2. Disconnect the hose (E), then remove the EVAP canister purge guard (F), and the canister purge valve (G).
  3. Install the parts in the reverse order of removal with a new O-ring (H).
scientia non olet · About LEMON Manuals