LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2010 >> Cobalt LS, 4D Sedan, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 30 (SRS (Supplemental Restraint System)) >> Side Impact Sensor (First) Replacement >> Installation

Side Impact Sensor (First) Replacement: Installation

WARNING: This page is about a different car, the 2011 Honda Insight and 2010 Honda Insight. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the side impact sensor (first) with a new TORX bolt (A), then connect the floor wire harness 4P connector (B) to the side impact sensor (first) (C).
    Fig 1: Side Impact Sensor (First) With TORX Bolt With Torque Specifications And Floor Wire Harness 4P Connector
    G06432307Courtesy of AMERICAN HONDA MOTOR CO., INC.
  2. Do the 12 volt battery terminal reconnection procedure (see 12 VOLT BATTERY TERMINAL DISCONNECTION AND RECONNECTION ).
  3. Connect the HDS and clear the DTCs (see HOW TO CLEAR DTCS  ).
  4. After installing the side impact sensor (first) confirm proper system operation: Turn the ignition switch to ON (II); the SRS indicator should come on for 6 seconds and then go off.
  5. Reinstall all removed parts.
scientia non olet · About LEMON Manuals