LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2010 >> Cobalt LS, 4D Sedan, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 30 (SRS (Supplemental Restraint System)) >> Side Airbag Replacement >> Removal

Side Airbag Replacement: Removal

WARNING: This page is about a different car, the 2011 Honda Insight and 2010 Honda Insight. However, it is still accessible from the selected car via links, so may be relevant.
  1. Do the 12 volt battery terminal disconnection procedure (see 12 VOLT BATTERY TERMINAL DISCONNECTION AND RECONNECTION ), then wait at least 3 minutes before starting work.
  2. Remove the front seat assembly (see FRONT SEAT REMOVAL/INSTALLATION ).
  3. Pull out the seat-back cover/pad as needed (see FRONT SEAT-BACK COVER REPLACEMENT ).
  4. Detach the clips (A) and wire ties (B) of side airbag harness from the seat cushion frame.
    Fig 1: Identifying Airbag Harness Clips And Wire Ties
    G00502233Courtesy of AMERICAN HONDA MOTOR CO., INC.
  5. Unzip the seat-cover from behind the seat-back (see FRONT SEAT REMOVAL/INSTALLATION ).
  6. Pull back the seat-back cover, then release the hook strips from the seat-back frame.
  7. Pull out the seat-back cover/pad as needed.
  8. Release the airbag attachment wire (A) from seat-back frame (B).
    Fig 2: Identifying Airbag Attachment Wire, Seat-Back Frame And Mounting Nut
    G06432282Courtesy of AMERICAN HONDA MOTOR CO., INC.
  9. Remove the mounting nut (C) and the side airbag (D).
scientia non olet · About LEMON Manuals