LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2010 >> Cobalt LS, 4D Sedan, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 30 (SRS (Supplemental Restraint System)) >> Rear Safing Sensor Replacement >> Removal

Rear Safing Sensor Replacement: Removal

WARNING: This page is about a different car, the 2011 Honda Insight and 2010 Honda Insight. However, it is still accessible from the selected car via links, so may be relevant.
  1. Do the 12 volt battery terminal disconnection procedure (see 12 VOLT BATTERY TERMINAL DISCONNECTION AND RECONNECTION ), then wait at least 3 minutes before starting work.
  2. Remove the rear seat cushion (see REAR SEAT REMOVAL/INSTALLATION ).
  3. Pull out the carpet as needed.
  4. Remove the two bolts (A) and the rear safing sensor cover (B).
    Fig 1: Identifying Rear Safing Sensor Cover And Bolts
    G06432310Courtesy of AMERICAN HONDA MOTOR CO., INC.
  5. Disconnect the floor wire harness 2P connector (C) from the rear safing sensor (D). using a TORX T30 bit, remove the TORX bolt (E), then remove the rear safing sensor.
scientia non olet · About LEMON Manuals