LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2010 >> Cobalt LS, 4D Sedan, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 30 (SRS (Supplemental Restraint System)) >> Rear Safing Sensor Replacement >> Installation

Rear Safing Sensor Replacement: Installation

WARNING: This page is about a different car, the 2011 Honda Insight and 2010 Honda Insight. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the rear safing sensor with a new TORX bolt (A), then connect the floor wire harness 2P connector (B) to the rear safing sensor (C).
    Fig 1: Rear Safing Sensor With TORX Bolt With Torque Specifications And Floor Wire Harness 2P Connector
    G06432311Courtesy of AMERICAN HONDA MOTOR CO., INC.
  2. Install the rear safing sensor cover (D) with two bolts (E).
  3. Do the 12 volt battery terminal reconnection procedure (see 12 VOLT BATTERY TERMINAL DISCONNECTION AND RECONNECTION ).
  4. Connect the HDS and clear the DTCs (see HOW TO CLEAR DTCS  ).
  5. Confirm proper SRS operation: Turn the ignition switch to ON (II); the SRS indicator should come on for about 6 seconds and then go off.
  6. Install all removed parts.
scientia non olet · About LEMON Manuals