Passenger's Airbag Cutoff Indicator Illumination Bulb Test/Replacement

WARNING: This page is about a different car, the 2011 Honda Insight and 2010 Honda Insight. However, it is still accessible from the selected car via links, so may be relevant.

With navigation: Remove the audio-navigation unit (see AUDIO-NAVIGATION UNIT REMOVAL/INSTALLATION ).
Without navigation: Remove the audio unit (see AUDIO UNIT REMOVAL/INSTALLATION ).
Turn the ignition switch to ON (II).
Measure the voltage between passenger's airbag cutoff indicator 4P connector terminal No. 3 and body ground. There should be 12 volt battery voltage.
- If there is 12 volt battery voltage, go to step 5.
- If there is no 12 volt battery voltage, check the No. 29 (10 A) fuse in the under-dash fuse/relay box. If the fuse is blown, replace it and retest. If the fuse blows again, check for a short in the No. 29 (10 A) fuse line.
Fig 1: Measuring Voltage Between Passenger's Airbag Cutoff Indicator 4P Connector Terminal No. 3 And Body Ground
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Reconnect the 4P connector to the passenger's airbag cutoff indicator.
Install a jumper wire between passenger's airbag cutoff indicator connector (4P) terminal No. 2 and body ground. The indicator should come on.
- If the indicator comes on, check the gauge control module circuit.
- If the indicator does not come on, go to step 7 to replace the passenger's airbag cutoff indicator.
Fig 2: Identifying Jumper Wire Between Passenger's Airbag Cutoff Indicator Connector (4P) Terminal No. 2 And Body Ground
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Turn the ignition switch to LOCK (0), and disconnect the passenger's airbag cutoff indicator 4P connector.
Remove the two screws (A) and the passenger's airbag cutoff indicator (B).

Fig 3: Identifying Passenger's Airbag Cutoff Indicator And Screws
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Reinstall the parts in the reverse order of removal.