Front Passenger's Weight Sensor Replacement: Removal
WARNING: This page is about a different car, the 2011 Honda Insight and 2010 Honda Insight. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
- Removal of the front passenger's weight sensors must be done according to the precautions/procedures described at the beginning of the SRS section (see PRECAUTIONS AND PROCEDURES ).
- The front passenger's weight sensor are part of the seat rail and must be replaced as an assembly.
- Do the 12 volt battery terminal disconnection procedure (see 12 VOLT BATTERY TERMINAL DISCONNECTION AND RECONNECTION ), then wait at least 3 minutes before starting work.
- Remove the front passenger's seat assembly (see FRONT SEAT REMOVAL/INSTALLATION ).
- Remove these items:
- Front seat cushion cover/pad (see FRONT SEAT CUSHION COVER REPLACEMENT )
- Front seat-back cover/pad (see FRONT SEAT-BACK COVER REPLACEMENT )
- Front seat belt buckle (see FRONT SEAT BELT BUCKLE )
- Front seat recline covers (see FRONT SEAT RECLINE COVER REMOVAL/INSTALLATION )
- Front seat cushion frame (see FRONT SEAT FRAME REPLACEMENT )
- Remove the TORX nuts (A) attaching the seat track (B) to the weight sensors (C) using a TORX E18 socket.
- Disconnect the sensor connectors (D) from the front passenger's weight sensor, then remove the front passenger's seat slide assembly (E) including both passenger's weight sensors.