LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2010 >> Cobalt LS, 4D Sedan, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 30 (SRS (Supplemental Restraint System)) >> Front Passenger's Weight Sensor Replacement >> Installation

Front Passenger's Weight Sensor Replacement: Installation

WARNING: This page is about a different car, the 2011 Honda Insight and 2010 Honda Insight. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
  • Make sure to install the harness wires so they are not pinched or interfering with other parts.
  • The spacers and collars can be identified by their color. Make sure to install the spacers and collars as shown.
  1. Install the new front passenger's seat slide assembly under the seat track.
    Fig 1: Identifying Front Passenger's Seat Slide Assembly Under Seat Track
    G06432313Courtesy of AMERICAN HONDA MOTOR CO., INC.
  2. When tightening the TORX nuts (A), tighten them in a crisscross pattern in two or more steps.
    Fig 2: TORX Nuts With Torque Specifications
    G06432314Courtesy of AMERICAN HONDA MOTOR CO., INC.
  3. Connect the sensor connectors (B) to the weight sensors.
    NOTE: The sensor connectors with the white tape (C) connect to the front sensors.
  4. Reassemble the front passenger's seat cushion cover/pad (see FRONT SEAT CUSHION COVER REPLACEMENT ).
  5. Reinstall the front passenger's seat (see FRONT SEAT REMOVAL/INSTALLATION ).
  6. Do the 12 volt battery terminal reconnection procedure (see 12 VOLT BATTERY TERMINAL DISCONNECTION AND RECONNECTION ).
  7. Connect the HDS and clear the DTCs (see HOW TO CLEAR DTCS  ).
  8. Do the front passenger's weight sensor initialization (see FRONT PASSENGER'S WEIGHT SENSOR INITIALIZATION  ).
  9. Confirm proper system operation: Turn the ignition switch to ON (II); the SRS indicator should come for about 6 seconds and then go off.
scientia non olet · About LEMON Manuals