LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2010 >> Cobalt LS, 4D Sedan, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 30 (SRS (Supplemental Restraint System)) >> Driver's Seat Position Sensor Replacement >> Removal

Driver's Seat Position Sensor Replacement: Removal

WARNING: This page is about a different car, the 2011 Honda Insight and 2010 Honda Insight. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: Do not turn the ignition switch to ON (II), and do not connect the battery cable while removing the driver's seat position sensor.
  1. Do the 12 volt battery terminal disconnection procedure (see 12 VOLT BATTERY TERMINAL DISCONNECTION AND RECONNECTION ), then wait at least 3 minutes before starting work.
  2. Raise the seat all the way up.
  3. Remove the recline cover (see FRONT SEAT RECLINE COVER REMOVAL/INSTALLATION ).
  4. Disconnect the seat position sensor harness 2P connector (A) from the driver's seat position sensor (B).
    Fig 1: Identifying Seat Position Sensor Harness 2P Connector And Driver's Seat Position Sensor
    G06432319Courtesy of AMERICAN HONDA MOTOR CO., INC.
  5. Remove the TORX bolt (C) using a TORX T30 bit, then remove the driver's seat position sensor.
scientia non olet · About LEMON Manuals