LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2010 >> Cobalt LS, 4D Sedan, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 30 (SRS (Supplemental Restraint System)) >> Driver's Seat Position Sensor Replacement >> Installation (Manual seat)

Installation (Manual seat)

WARNING: This page is about a different car, the 2011 Honda Insight and 2010 Honda Insight. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
  • Be sure to install the harness so it does not pinched or interfere with other parts.
  • Do not turn the ignition switch to ON (II), and do not connect the battery cable while installing the driver's seat position sensor.
  1. Install the driver's seat position sensor (A) with a new TORX bolt (B).
    Fig 1: Driver's Seat Position Sensor With TORX Bolt With Torque Specifications
    G06432320Courtesy of AMERICAN HONDA MOTOR CO., INC.
  2. Connect the seat position sensor harness 2P connector (C) to the driver's seat position sensor.
  3. Install the recline cover (see FRONT SEAT RECLINE COVER REMOVAL/INSTALLATION ).
  4. Do the 12 volt battery terminal reconnection procedure (see 12 VOLT BATTERY TERMINAL DISCONNECTION AND RECONNECTION ).
  5. Connect the HDS and clear the DTCs (see HOW TO CLEAR DTCS  ).
  6. Check the operation of the driver's seat position sensor with the HDS (see FRONT PASSENGER'S WEIGHT SENSOR OUTPUT CHECK AFTER A VEHICLE COLLISION  ).
scientia non olet · About LEMON Manuals