LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2010 >> Cobalt LS, 4D Sedan, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 30 (SRS (Supplemental Restraint System)) >> Driver's Airbag Replacement >> Removal

Driver's Airbag Replacement: Removal

WARNING: This page is about a different car, the 2011 Honda Insight and 2010 Honda Insight. However, it is still accessible from the selected car via links, so may be relevant.
  1. Do the 12 volt battery terminal disconnection procedure (see 12 VOLT BATTERY TERMINAL DISCONNECTION AND RECONNECTION ), then wait at least 3 minutes before starting work.
  2. Remove the access panel (A) from the steering wheel, then disconnect the driver's airbag 4P connector (B) and horn switch 1P connector (C) from the cable reel.
    Fig 1: Identifying Access Panel And Steering Wheel
    G06432271Courtesy of AMERICAN HONDA MOTOR CO., INC.
  3. Using a TORX T30 bit, remove the two TORX bolts (A).
    Fig 2: Identifying Driver's Airbag And TORX Bolts
    G06432272Courtesy of AMERICAN HONDA MOTOR CO., INC.
  4. Remove the driver's airbag (B).
scientia non olet · About LEMON Manuals