LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2010 >> Cobalt LS, 4D Sedan, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 30 (SRS (Supplemental Restraint System)) >> Driver's Airbag Replacement >> Installation

Driver's Airbag Replacement: Installation

WARNING: This page is about a different car, the 2011 Honda Insight and 2010 Honda Insight. However, it is still accessible from the selected car via links, so may be relevant.
  1. Place the driver's airbag (A) in the steering wheel, and secure it with new TORX bolts (B).
    NOTE: Make sure the clearance (C) between the steering wheel and horn pad is the specified value.
    Fig 1: Driver's Airbag In Steering Wheel And TORX Bolts With Torque Specifications
    G06432273Courtesy of AMERICAN HONDA MOTOR CO., INC.
  2. Connect the driver's airbag 4P connector (A) and horn switch 1P connector (B) of the cable reel, then install the access panel (C) on the steering wheel.
    Fig 2: Identifying Driver's Airbag 4P Connector And Horn Switch 1P Connector
    G06432274Courtesy of AMERICAN HONDA MOTOR CO., INC.
  3. Do the 12 volt battery terminal reconnection procedure (see 12 VOLT BATTERY TERMINAL DISCONNECTION AND RECONNECTION ).
  4. Connect the HDS, and clear the DTCs (see HOW TO CLEAR DTCS  ).
  5. After installing the airbag, confirm proper system operation:
    • Turn the ignition switch to ON (II); the SRS indicator should come on for about 6 seconds and then go off.
    • Make sure the horn and turn signal switches work properly.
    • Make sure the steering wheel switches work properly.
scientia non olet · About LEMON Manuals