LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2010 >> Cobalt LS, 4D Sedan, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 30 (SRS (Supplemental Restraint System)) >> Airbag and Tensioner Disposal >> Deployment Tool Check

Deployment Tool Check

WARNING: This page is about a different car, the 2011 Honda Insight and 2010 Honda Insight. However, it is still accessible from the selected car via links, so may be relevant.
  1. Connect the yellow clips to both switch protector handles on the tool.
  2. Then connect the red lead to the positive battery post and the black lead to the negative battery post.
  3. Push the operation switch: The green light should come on, indicating that the tool is operating properly and is ready for use. If the red light stays on, the tool is faulty, and another one must be used for the procedure.
  4. Disconnect the tool clips and connectors from the protector handles and the 12 volt battery.
scientia non olet · About LEMON Manuals