IMA system indicator stays on, no DTCs set
WARNING: This page is about a different car, the 2011 Honda Insight and 2010 Honda Insight. However, it is still accessible from the selected car via links, so may be relevant.
- Turn the ignition switch to LOCK (0).
- Connect the HDS to the DLC (see GENERAL TROUBLESHOOTING INFORMATION ).
- Turn the ignition switch to ON (II), and select the IMA SYSTEM.
Does the HDS communicate with the IMA system?
YES -go to step 4.
NO -Do the DLC circuit troubleshooting (see DLC CIRCUIT TROUBLESHOOTING ).
- Do the gauge self-diagnostic function (see
SELF-DIAGNOSTIC FUNCTION
).
Does the IMA system indicator flash?
YES -The system is OK at this time.
NO -Substitute a known-good gauge control module, and recheck. If the IMA system indicator is OK, replace the original gauge control module.