Troubleshooting Circuits at the MCM Connectors
WARNING: This page is about a different car, the 2011 Honda Insight and 2010 Honda Insight. However, it is still accessible from the selected car via links, so may be relevant.
Special Tools Required
- Digital Multimeter KS-AHM-32-003*
- Backprobe Set 07SAZ-001000A (2)
*Available through the Honda Tool and Equipment Program 888-424-6857
If DTC troubleshooting requires voltage or resistance checks at the MCM connectors, remove the MCM connectors before doing the checks.
- Remove the IPU cover (see IPU COVER REMOVAL/INSTALLATION ).
- Remove the PCU lid, the PCU busplate, and the PCU cover (see MOTOR CONTROL MODULE (MCM) REMOVAL/INSTALLATION ).
- Connect the backprope adapters (A) to the stacking patch cords (B), and connect the cords to a digital multimeter.