DTC P0BE6 (86): U Phase Motor Current Sensor Circuit Malfunction
- Before you troubleshoot, record all freeze data and any on-board snapshot, and review the general troubleshooting information (see GENERAL TROUBLESHOOTING INFORMATION ).
- If the DTC cannot be cleared, do the troubleshooting for DTC U1204 (55).
- Turn the ignition switch to ON (II).
- Clear the DTC with the HDS (see DTC CLEAR ).
- Monitor the OBD STATUS for DTC P0BE6 (86) in the DTCs MENU with the HDS.
Does the screen indicate FAILED?
YES -go to step 4.
NO -If the screen indicates PASSED, intermittent failure, the system is OK at this time. If the screen indicates NOT COMPLETED, go to step 1.
- Check for Pending or Confirmed DTCs with the HDS.
Is DTC P0A5E (24) and/or P0A5F (25) indicated?
YES -Do the troubleshooting for DTC P0A5E (24) (see DTC P0A5E (24): U PHASE MOTOR CURRENT SENSOR CIRCUIT LOW VOLTAGE ) and/or DTC P0A5F (25) (see DTC P0A5F (25): U PHASE MOTOR CURRENT SENSOR CIRCUIT HIGH VOLTAGE ).
NO -Replace the phase motor current sensor (see MOTOR POWER INVERTER (MPI) MODULE REMOVAL/INSTALLATION ), then go to step 5.
- Turn the ignition switch to ON (II).
- Check for Pending or Confirmed DTCs with the HDS.
Is DTC P0BE6 (86) indicated?
YES -go to step 1.
NO -go to step 7.
- Monitor the OBD STATUS for DTC P0BE6 (86) in the DTCs MENU with the HDS.
Does the screen indicate PASSED?
YES -Troubleshooting is complete. If any other Pending or Confirmed DTCs were indicated in step 6, go to the indicated DTC's troubleshooting.
NO -If the screen indicates FAILED, go to step 1. If the screen indicates NOT COMPLETED, keep the ignition switch ON (II) until a result comes on.