A-Pillar Corner Trim Replacement

WARNING: This page is about a different car, the 2011 Honda Insight and 2010 Honda Insight. However, it is still accessible from the selected car via links, so may be relevant.

Special Tools Required

KTC Trim Tool Set SOJATP2014*

*Available through the Honda Tool and Equipment Program, 888-424-6857

NOTE:

Put on gloves to protect your hands.
Take care not to scratch the corner trim and the body.
Use the appropriate tool from the KTC trim tool set to avoid damage when removing components.

Open the front door.
Carefully insert the appropriate trim tool (A) next to the body, and detach the clips by prying on the A-pillar corner trim (B).

Fig 1: Identifying Trim Tool And A-Pillar Corner Trim
Courtesy of AMERICAN HONDA MOTOR CO., INC.
While sliding the A-pillar corner trim rearward in the direction shown, detach the tab (A) from the body, then remove the trim.

Fig 2: Identifying Tab
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Install the A-pillar corner trim in the reverse order of removal, and note these items:
- If the clips are damaged or stress-whitened, replace them with new ones.
- Push the clips into place securely.