Immobilizer indicator does not go off

WARNING: This page is about a different car, the 2011 Honda Insight and 2010 Honda Insight. However, it is still accessible from the selected car via links, so may be relevant.

Turn the ignition switch to LOCK (0).
Connect the HDS to the data link connector.
Turn the ignition switch to ON (II).
From the main menu, enter IMMOBI, then select IMMOBILIZER SET UP, then select System Check, Number of keys, and Status Log.
Do the SYSTEM CHECK with the HDS.
Is N-1 OK indicated?

YES -Replace the gauge control module (see GAUGE CONTROL MODULE REPLACEMENT ).

NO -Substitute a known-good immobilizer-keyless control unit, then register it and recheck. If the symptom goes away, replace the original immobilizer-keyless control unit (see IMMOBILIZER-KEYLESS CONTROL UNIT REPLACEMENT ).