LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2010 >> Cobalt LS, 4D Sedan, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 15 (Heating, Ventilation And Air Conditioning) >> Climate Control >> General Troubleshooting Information >> How to Check for DTCs with the HDS

How to Check for DTCs with the HDS

WARNING: This page is about a different car, the 2011 Honda Insight and 2010 Honda Insight. However, it is still accessible from the selected car via links, so may be relevant.
  1. Make sure the ignition switch to LOCK (0).
  2. Connect the HDS to the data link connector (DLC) (A) located under the driver's side of the dashboard.
    Fig 1: Identifying Data Link Connector
    G06431256Courtesy of AMERICAN HONDA MOTOR CO., INC.
  3. Turn the ignition switch to ON (II).
  4. Make sure the HDS communicates with the vehicle and the climate control unit. If it doesn't, troubleshoot the DLC circuit (see DLC CIRCUIT TROUBLESHOOTING ).
  5. Select HVAC/CLIMATE CONTROL in the BODY ELECTRICAL menu.
  6. Select DTCs in the HVAC/CLIMATE CONTROL menu.
  7. Check for DTCs. If any DTCs are indicated, write down the DTCs, then go to the indicated DTC troubleshooting. If no DTCs are indicated, refer to symptom troubleshooting.
    NOTE:
    • After troubleshooting, clear the DTCs with the HDS.
    • For specific operations, refer to the user's manual that came with the HDS.
scientia non olet · About LEMON Manuals