LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2010 >> Cobalt LS, 4D Sedan, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 11 (Continuously Variable Transmission (CVT)) >> Transmission Housing >> Selector Control Shaft Removal/Installation

Selector Control Shaft Removal/Installation

WARNING: This page is about a different car, the 2011 Honda Insight and 2010 Honda Insight. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the bolt (A) and the lock washer (B), then remove the control lever (C) from the selector control shaft (D).
    Fig 1: Lock Washer With Torque Specifications, Control Lever And Selector Control Shaft
    G06430346Courtesy of AMERICAN HONDA MOTOR CO., INC.
  2. Remove the selector control shaft from the transmission housing.
  3. Check for fluid leaks between the transmission housing and the oil seal (E). If there is a fluid leak, replace the oil seal with a new one.
  4. Install the selector control shaft in the transmission housing, and install the control lever on the selector control shaft.
  5. Install the bolt with a new lock washer.
scientia non olet · About LEMON Manuals