LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2010 >> Cobalt LS, 4D Sedan, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 11 (Continuously Variable Transmission (CVT)) >> Lower Valve Body >> Inhibitor Solenoid Removal/Installation

Inhibitor Solenoid Removal/Installation

WARNING: This page is about a different car, the 2011 Honda Insight and 2010 Honda Insight. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the inhibitor solenoid connector (A).
    Fig 1: Inhibitor Solenoid With Torque Specifications And Connector
    G06430331Courtesy of AMERICAN HONDA MOTOR CO., INC.
  2. Remove the inhibitor solenoid (B), then remove the two O-rings from the inhibitor solenoid.
  3. Install the two O-rings (C) on the inhibitor solenoid, then install the inhibitor solenoid on the CVT driven pulley pressure control solenoid valve.
  4. Connect the inhibitor solenoid connector.
scientia non olet · About LEMON Manuals