LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2010 >> Cobalt LS, 4D Sedan, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 11 (Continuously Variable Transmission (CVT)) >> Lower Valve Body >> CVT Driven Pulley Pressure Control Solenoid Valve Removal/Installation

CVT Driven Pulley Pressure Control Solenoid Valve Removal/Installation

WARNING: This page is about a different car, the 2011 Honda Insight and 2010 Honda Insight. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the CVT driven pulley pressure control solenoid valve connector (A) and the inhibitor solenoid connector (B).
    Fig 1: CVT Driven Pulley Pressure Control Solenoid Valve With Torque Specifications And Inhibitor Solenoid Connector
    G06430330Courtesy of AMERICAN HONDA MOTOR CO., INC.
  2. Remove the CVT driven pulley pressure control solenoid valve (C) (eight bolts), and remove the inhibitor solenoid (D) from the CVT driven pulley pressure control solenoid valve.
  3. Check that the filter (E) is in good condition, and replace it if it is clogged or damaged.
  4. Remove the two O-rings (F) from the inhibitor solenoid.
  5. Install the two O-rings on the inhibitor solenoid, then install the inhibitor solenoid on the CVT driven pulley pressure control solenoid valve.
  6. Install the CVT driven pulley pressure control solenoid valve (eight bolts) with the two dowel pins (G) and the separator plate (H) on the lower valve body (I).
  7. Connect the CVT driven pulley pressure control solenoid valve connector and the inhibitor solenoid connector.
scientia non olet · About LEMON Manuals