LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2010 >> Cobalt LS, 4D Sedan, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 11 (Continuously Variable Transmission (CVT)) >> Lower Valve Body >> CVT Drive Pulley Pressure Control Solenoid Valve Removal/Installation

CVT Drive Pulley Pressure Control Solenoid Valve Removal/Installation

WARNING: This page is about a different car, the 2011 Honda Insight and 2010 Honda Insight. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the solenoid wire harness clamp (A).
    Fig 1: Bolts With Torque Specifications And CVT Drive Pulley Pressure Control Solenoid Valve Connector
    G06430329Courtesy of AMERICAN HONDA MOTOR CO., INC.
  2. Disconnect the CVT drive pulley pressure control solenoid valve connector (B).
  3. Remove the seven bolts, and remove the CVT drive pulley pressure control solenoid valve (C). The CVT clutch pressure control solenoid valve (D) can also be removed.
  4. Check that the filters (E) are in good condition, replace them if these are clogged or damaged.
  5. Install the CVT drive pulley pressure control solenoid valve with the two dowel pins (F), the separator plate (G), the CVT clutch pressure control solenoid valve with the two dowel pins (H), and the separator plate (I) on the lower valve body (J).
  6. Connect the CVT drive pulley pressure control solenoid valve connector.
  7. Install the solenoid wire harness clamp.
scientia non olet · About LEMON Manuals