How to End a Troubleshooting Session (required after any troubleshooting)

WARNING: This page is about a different car, the 2011 Honda Insight and 2010 Honda Insight. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: Reset the PCM with the HDS while the engine is stopped.

Turn the ignition switch to LOCK (0).
Turn the ignition switch to ON (II), and wait for 30 seconds.
Turn the ignition switch to LOCK (0), and disconnect the HDS from the DLC.
Do the PCM idle learn procedure (see PCM IDLE LEARN PROCEDURE ).
Start the engine with the shift lever in P or N, and warm it up to normal operating temperature (the radiator fan comes on twice).
To verify that the problem is repaired, test-drive the vehicle for several minutes at speeds over 31 mph (50 km/h) or under the same conditions as those indicated by the freeze data.