Input Shaft Oil Seal Replacement

WARNING: This page is about a different car, the 2011 Honda Insight and 2010 Honda Insight. However, it is still accessible from the selected car via links, so may be relevant.

Special Tools Required

Driver Handle, 15 x 135L 07749-0010000
Attachment, 37 x 40 mm 07746-0010200

Remove the input shaft oil seal from the flywheel housing.

Fig 1: Removing Input Shaft Oil Seal
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Install a new oil seal flush with 3±0.5 mm (0.12±0.02 in) (A) below flywheel housing level. Using the driver handle and the 37 x 40 mm attachment.

Fig 2: Installing Input Shaft Oil Seal
Courtesy of AMERICAN HONDA MOTOR CO., INC.