LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2010 >> Cobalt LS, 4D Sedan, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 11 (Continuously Variable Transmission (CVT)) >> End Cover >> CVTF Feed Pipe Replacement

CVTF Feed Pipe Replacement

WARNING: This page is about a different car, the 2011 Honda Insight and 2010 Honda Insight. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the two feed pipe flange plates (A) (three bolts), then remove the two feed pipes (B) and two feed pipe flanges (C) from the end cover (D).
    NOTE: Replace the end cover if replacement of the unremovable two CVTF feed pipes (E) is required.
    Fig 1: Feed Pipe Flange Plates With Torque Specifications, Feed Pipes And Feed Pipe Flanges
    G06430336Courtesy of AMERICAN HONDA MOTOR CO., INC.
  2. Remove the O-rings (F) from the two CVTF feed pipes and the two feed pipe flanges, then replace the two CVTF feed pipes.
  3. Check the two feed pipe flange plates and the two feed pipe flanges for wear or damage, and replace them if necessary.
  4. Install new O-rings over two new CVTF feed pipes and on the two feed pipe flanges.
  5. Install the feed pipe (A) through the feed pipe flange (B) by aligning the feed pipe tab (C) with the guide (D) on the flange.
    Fig 2: Identifying Feed Pipe, Feed Pipe Flange And Guide
    G06430337Courtesy of AMERICAN HONDA MOTOR CO., INC.
  6. Install the CVTF feed pipe over the unremovable feed pipe (E), and align the mark (F) on the feed pipe flange between the tabs (G) on the end cover.
  7. Install the feed pipe flange plate.
scientia non olet · About LEMON Manuals