LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2010 >> Cobalt LS, 4D Sedan, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 11 (Continuously Variable Transmission (CVT)) >> CVT Input Shaft (Drive Pulley) Speed Sensor Replacement

CVT Input Shaft (Drive Pulley) Speed Sensor Replacement

WARNING: This page is about a different car, the 2011 Honda Insight and 2010 Honda Insight. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the air cleaner (see AIR CLEANER REMOVAL/INSTALLATION ).
  2. Disconnect the CVT input shaft (drive pulley) speed sensor connector, then remove the CVT input shaft (drive pulley) speed sensor (A).
    Fig 1: O-Ring And CVT Input Shaft (Drive Pulley) Speed Sensor With Torque Specifications
    G06430126Courtesy of AMERICAN HONDA MOTOR CO., INC.
  3. Install a new O-ring (B) on a new CVT input shaft (drive pulley) speed sensor, then install the CVT input shaft (drive pulley) speed sensor in the transmission housing.
  4. Check the connector for rust, dirt, or oil, and clean or repair if necessary then connect the connector securely.
  5. Install the air cleaner (see AIR CLEANER REMOVAL/INSTALLATION ).
scientia non olet · About LEMON Manuals