LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2010 >> Cobalt LS, 4D Sedan, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 11 (Continuously Variable Transmission (CVT)) >> CVT Drive Pulley Pressure Control Solenoid Valve Replacement

CVT Drive Pulley Pressure Control Solenoid Valve Replacement

WARNING: This page is about a different car, the 2011 Honda Insight and 2010 Honda Insight. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the lower valve body (see LOWER VALVE BODY REMOVAL/INSTALLATION  ).
  2. Remove the solenoid wire harness clamp (A).
    Fig 1: CVT Drive Pulley Pressure Control Solenoid Valve Connector And Bolts With Torque Specifications
    G06430123Courtesy of AMERICAN HONDA MOTOR CO., INC.
  3. Disconnect the CVT drive pulley pressure control solenoid valve connector (B).
  4. Remove the seven bolts, and remove the CVT drive pulley pressure control solenoid valve (C). The CVT clutch pressure control solenoid valve (D) can also be removed.
  5. Check that the filters (E) are in good condition, replace them if these are clogged or damaged.
  6. Install a new CVT drive pulley pressure control solenoid valve with the dowel pins (F), the separator plate (G), the CVT clutch pressure control solenoid valve with the dowel pins (H) and the separator plate (I) on the lower valve body (J).
  7. Connect the CVT drive pulley pressure control solenoid valve connector.
  8. Install the solenoid wire harness clamp.
  9. Install the lower valve body (see LOWER VALVE BODY REMOVAL/INSTALLATION  ).
scientia non olet · About LEMON Manuals