Oil Seal Replacement

WARNING: This page is about a different car, the 2011 Honda Insight and 2010 Honda Insight. However, it is still accessible from the selected car via links, so may be relevant.

Special Tools Required

Driver Handle, 15 x 135L 07749-0010000
Attachment, 78 x 80 mm 07NAD-PX40100
Oil Seal Driver Attachment 07JAD-PH80101

Remove the oil seal from the transmission housing.

Fig 1: Removing Oil Seal From Transmission Housing
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Remove the oil seal from the flywheel housing.

Fig 2: Removing Oil Seal From Flywheel Housing
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Install a new oil seal flush to the transmission housing using the 15 x 135L driver handle and the 78 x 80 mm attachment.

Fig 3: Installing Oil Seal to Transmission Housing
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Install a new oil seal flush with the flywheel housing using the 15 x 135L driver handle and the oil seal driver attachment.

Fig 4: Installing Oil Seal To Flywheel Housing
Courtesy of AMERICAN HONDA MOTOR CO., INC.