Carrier Bearing Replacement

WARNING: This page is about a different car, the 2011 Honda Insight and 2010 Honda Insight. However, it is still accessible from the selected car via links, so may be relevant.

Special Tools Required

Driver Handle, 40 mm I.D. 07746-0030100

Remove the carrier bearing (A) using a commercially available puller (B) and a spacer (C).

Fig 1: Removing Carrier Bearing
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Install the new bearing using the 40 mm driver handle and a press. Press the bearing on until it bottoms.

Fig 2: Installing Carrier Bearing
Courtesy of AMERICAN HONDA MOTOR CO., INC.