TPMS Reminder Reset - Procedure 07: Notes

WARNING: This page does not describe the selected car, but rather 254 other vehicles, including the 2025 Honda Odyssey, 2025 Honda HR-V, 2025 Honda Civic, 2025 Honda CR-V, and 2025 Honda Accord. However, it is still accessible from the selected car via links, so may be relevant.

This vehicle is equipped with an indirect TPMS that doesn't use tire pressure sensors mounted inside the tires. It uses the existing VSA wheel speed sensors to monitor and compare tire characteristics while driving.

The calibration begins when the TPMS switch is pressed or the calibration is selected through the Multi-information display. The calibration is completed after driving 31 to 62 mph (50 to 100 km/h), steadily without much acceleration or deceleration for about 19 minutes.

TPMS calibration is required after performing any of the following actions:

Adjusting tire pressures
Rotating the tires
Replacing the tires
Updating/replacing the VSA modulator-control unit

Calibration begins when TPMS switch is pressed (Models Without ACC) or Calibration is selected through the Multi-information display (Models With ACC). The process finishes automatically as the vehicle is driven. This takes about 30 minutes of cumulative driving at 30 to 60 mph.