Calibration Check Method
WARNING: This page does not describe the selected car, but rather 254 other vehicles, including the 2025 Honda Odyssey, 2025 Honda HR-V, 2025 Honda Civic, 2025 Honda CR-V, and 2025 Honda Accord. However, it is still accessible from the selected car via links, so may be relevant.
The calibration check process gets interrupted if the vehicle moves. Do the troubleshooting if the indicator does not go off after 2 seconds, keeps blinking or stays on when the vehicle is in the ON mode.
Check if calibration is completed by following these procedures:
- Stop the vehicle and shift into P or N position.
- Turn the vehicle to the OFF (LOCK) mode.
- Turn the vehicle to the ON mode and wait to see the low pressure indicator come on for 2 seconds and then off.
- Do not drive the vehicle and wait for 45 seconds as is.
- If the calibration is completed, the indicator does not come on. If the calibration is not yet completed, then the indicator comes on for 2 seconds and then goes off.