TPMS Reminder Reset - Procedure 04

WARNING: This page does not describe the selected car, but rather 254 other vehicles, including the 2025 Honda Odyssey, 2025 Honda HR-V, 2025 Honda Civic, 2025 Honda CR-V, and 2025 Honda Accord. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: Make sure the tire pressure is properly adjusted to the specified tire pressure listed on the doorjamb label before doing the TPMS calibration.

Do the TPMS calibration after doing the following items:

Adjust the tire pressure
Rotating the tires
Replacing the tires
Update/replace the VSA modulator-control unit

The calibration begins when the calibration is selected through the MID (multi-information display). The calibration is completed after driving in an ideal driving condition (28 to 65 mph (45 to 105 km/h), driving steadily without much acceleration or deceleration) for about 19 minutes. Full functionality of the system cannot be performed properly if the calibration is not completed.

Turn the ignition switch to ON (II), or the engine start/stop button is pressed to select the ON mode.
NOTE: Vehicle must be stopped with the transmission in neutral (M/T) or P or N (A/T and CVT).
Press the MENU button (left side of steering wheel) to enter the customizing mode.
Press the AUDIO REMOTE + or - button to select CUSTOMIZE SETTINGS > TPMS CALIBRATION > INITIALIZE.
Press the AUDIO REMOTE + or - button to select YES.
When the calibration successfully begins, "TPMS CALIBRATION HAS BEEN INITIALIZED" gets displayed on MID when the system received the calibration.

NOTE: If the calibration does not begin successfully, "UNABLE TO INITIALIZE TPMS CALIBRATION" gets displayed on MID. Troubleshoot the TPMS.