Engine Oil Replacement Reminder Reset - Procedure 02
WARNING: This page does not describe the selected car, but rather 254 other vehicles, including the 2025 Honda Odyssey, 2025 Honda HR-V, 2025 Honda Civic, 2025 Honda CR-V, and 2025 Honda Accord. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
- The vehicle must be stopped to reset the display. If a required service is done and the display is not reset, or if the maintenance display is reset without doing the service, the system will not show the proper maintenance timing. This can lead to serious mechanical problems because there will be no accurate record of when the required maintenance is needed.
- The engine oil life and the maintenance items can be reset independently only with the HDS.
- Turn the ignition switch to ON (II).
- Push and release the Select/Reset knob repeatedly until the engine oil life indicator is displayed.
- Press and hold the Select/Reset knob for about 10 seconds. The information display shows the reset mode display.NOTE: If you are resetting the display when the engine oil life is more than 15%, make sure any maintenance items requiring service are done before resetting the display.
- Twist the Select/Reset knob to select OIL LIFE, the display will begin to blink.
- Push in on the Select/Reset knob to enter this selection, the OIL LIFE and the maintenance item codes will begin to blink.
- Press and hold the Select/Reset knob again for about 5 seconds. The maintenance item codes will disappear, and the engine oil life will reset to 100%.