LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2010 >> Cobalt LS, 4D Sedan, Automatic >> Repair and Diagnosis >> Brakes >> Mechanical - Hydraulic >> Drum Brake System >> Repair Instructions >> Drum Brake Hardware Replacement >> Installation Procedure

Installation Procedure

    Fig 1: Lower Brake Shoe Return Spring
    GM2180686Courtesy of GENERAL MOTORS CORP.
  1. Install the lower brake shoe return spring (1).
    2. Fig 2: Primary Brake Shoe
    GM2180683Courtesy of GENERAL MOTORS CORP.
  2. Position the primary brake shoe (1) to the drum brake backing plate and connect the brake shoe to the lower brake shoe return spring.
    3. Fig 3: Upper Brake Shoe Return Spring
    GM2180682Courtesy of GENERAL MOTORS CORP.
  3. Install the upper brake shoe return spring (1).
    4. Fig 4: Brake Shoe Adjuster
    GM2180677Courtesy of GENERAL MOTORS CORP.
  4. Spread the top of the brake shoes apart slightly and install the brake shoe adjuster (1).
    5. Fig 5: Brake Shoe Hold Down Spring And Cup
    GM2180676Courtesy of GENERAL MOTORS CORP.
  5. Install the 2 hold down spring and cup assembly pins.
  6. Install the brake shoe hold down spring and cup (1) assemblies by compressing the spring and rotating the assembly 1/4 turn.
    7. Fig 6: Brake Adjuster Actuator Lever
    GM2180674Courtesy of GENERAL MOTORS CORP.
  7. Install the brake adjuster actuator lever (1).
    8. Fig 7: Brake Adjuster Actuator Lever Spring
    GM2180668Courtesy of GENERAL MOTORS CORP.
  8. Install the brake adjuster actuator lever spring (1).
  9. Adjust the drum brakes. Refer to Drum Brake Adjustment .
  10. Install the brake drum. Refer to Brake Drum Replacement .
scientia non olet · About LEMON Manuals