LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2010 >> Cobalt LS, 4D Sedan, Automatic >> Repair and Diagnosis >> Accessories & Equipment >> Interior/Exterior Trim >> Seat Hardware, Seat Trim, And Upholstery >> Repair Instructions >> Rear Seat Back Cushion Latch Replacement >> Removal Procedure

Removal Procedure

    Fig 1: Lower Lock Pillar Molding
    GM1734064Courtesy of GENERAL MOTORS CORP.
  1. Remove the fastener (1) from the lower lock pillar garnish molding. Sedan shown, coupe similar. Fold the garnish trim away from the latch.
    2. Fig 2: View Of Latch Assembly
    GM876786Courtesy of GENERAL MOTORS CORP.
  2. Remove the latch bolts.
    3. Fig 3: View Of Latch Release Cable
    GM876787Courtesy of GENERAL MOTORS CORP.
  3. Disengage the clip holding the latch release handle to the rear compartment shelf.
  4. Remove the rosebud fastener which retains the latch cable to the rear compartment shelf.
    5. Fig 4: View Of Latch Assembly Grommet
    GM888319Courtesy of GENERAL MOTORS CORP.
  5. Remove the grommet from the sheet metal.
  6. Pull the latch assembly into the passenger compartment.
  7. Remove the latch assembly from the vehicle.
scientia non olet · About LEMON Manuals