LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2010 >> Camaro LS, Automatic >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 9 (Engine Controls And Fuel - 6.2L - DTC P0315 To DTC P1258) >> DTC P0641 or P0651 (ECM) >> Circuit/System Testing

Circuit/System Testing

WARNING: This page is about a different variant/trim than selected.
NOTE: A short to voltage on the signal circuit of certain components may cause this DTC to set.
  1. Ignition OFF, disconnect the harness connector of all the sensors for the applicable DTC. Refer to Diagnostic Aids for the appropriate sensors.
  2. Ignition ON, measure for 4.8-5.2 V between the 5 V reference circuit of each component and ground.
    • If less than the specified range, test for a short to ground or an open/high resistance on the 5 V reference circuits of each component. If all circuits test normal, replace the K20 ECM.
    • If greater than the specified range, test for a short to voltage on the 5 V reference circuit of each component. If all circuits test normal, replace the K20 ECM.
  3. Connect each component associated with the 5 V reference circuit, one at a time, while monitoring the voltage. Verify the voltage remains between 4.8-5.2 V.
    • If not within the specified range when a component is connected, test the signal circuit for a short to voltage. If the circuit tests normal, replace the appropriate component.
scientia non olet · About LEMON Manuals