Conditions for Running the DTC
WARNING: This page is about a different variant/trim than selected.
- DTCs P0068, P0101, P0102, P0103, P0106, P0107, P0108, P0112, P0113, P0117, P0118, P0120, P0122, P0123, P0171, P0172, P0201, P0202, P0203, P0204, P0205, P0206, P0207, P0208, P0220, P0221, P0222, P0223, P0230, P0300, P0336, P0442, P0446, P0449, P0452, P0453, P0455, P0462, P0463, P0496, P1516, P2101, P2135, P2176 are not set.
- The engine has been running for greater than 60 s.
- The engine is idling for greater than 10 s.
- The AC mode state has not changed.
- The power steering load state has not changed.
- The transmission gear selector state has not changed.
- The engine coolant temperature (ECT) is greater than -60°C (-76°F).
- The intake air temperature (IAT) is greater than -20°C (-4°F).
- The barometric pressure (BARO) is greater than 70 kPa.
- The system voltage is between 11-18 V.
- The vehicle speed is less than 4.8 km/h (2 mph).
- The DTCs run continuously when the above conditions are met.