LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2010 >> Camaro LS, Automatic >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 9 (Engine Controls And Fuel - 6.2L - DTC P0315 To DTC P1258) >> DTC P0446 >> Circuit/System Verification

Circuit/System Verification

WARNING: This page is about a different variant/trim than selected.
  1. Ignition ON and fuel cap removed, verify that the Fuel Tank Pressure Sensor parameter is between 1.3-1.7 V.
    • If not within the specified range, go to the fuel tank pressure sensor section in Circuit/System Testing.
  2. Install the fuel cap.
  3. With the engine running, the EVAP canister vent solenoid valve open, use a scan tool to command the EVAP canister purge solenoid valve to 100 %. The fuel tank vacuum should not increase to more than -15 mmHg (-8 inches H2O).
    • If the fuel tank vacuum is greater than the specified range, go to the restriction section in Circuit/System Testing.
  4. Using the scan tool, decrease the canister purge duty cycle from 100 % to 0 %. The vacuum should decrease to near zero.
    • If the fuel tank vacuum does not return to zero or appears to decrease too slowly go to the restriction section in Circuit/System Testing.
  5. Operate the vehicle within the Conditions for Running the DTC. You may also operate the vehicle within the conditions that you observed from the Freeze Frame/Failure Records data.
scientia non olet · About LEMON Manuals