Circuit/System Description

WARNING: This page is about a different variant/trim than selected.

An ignition voltage is supplied directly to the evaporative emission (EVAP) canister purge solenoid valve. The engine control module (ECM) grounds the evaporative emission canister purge solenoid valve control circuit through an internal switch called a driver. The ECM monitors the status of the driver. The evaporative emission canister purge solenoid valve is pulse width modulated (PWM). A scan tool will display the amount of ON time as a percentage.

Battery voltage is supplied to the evaporative emission canister solenoid valve. The ECM grounds the evaporative emission canister vent solenoid valve control circuit through an internal switch called a driver. The ECM monitors the status of the driver. A scan tool will display the commanded state of the evaporative emission canister vent solenoid valve as ON or OFF.