LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2010 >> Camaro LS, Automatic >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 9 (Engine Controls And Fuel - 6.2L - DTC P0315 To DTC P1258) >> DTC P0442 >> Circuit/System Testing

Circuit/System Testing

WARNING: This page is about a different variant/trim than selected.
NOTE:
  • Refer to the J 41413-200:  EEST operation manual for detailed instructions in Evaporative Emission System Diagnosis .
  • Larger volume fuel tanks and/or those with lower fuel levels may require several minutes for the floating indicator to stabilize.
  • Ensure that the underbody temperature of the vehicle and the tester are similar.
  1. Disconnect the purge tube at the quick connector on the evaporative emission canister side of the Q12 evaporative emission canister purge solenoid valve and install the CH 48096:  Port Tool.
  2. Connect the J 41413-200:  EEST to the CH 48096:  Port Tool.
  3. Ignition ON, using a scan tool close the evaporative emission canister vent solenoid valve to seal the evaporative emission system.
  4. Use the flow meter on the J 41413-200:  EEST, calibrated to 0.51 mm (0.020 in) to determine that there is no leak in the evaporative emission system.
    • If a leak is detected, use the J 41413-200:  EEST to apply smoke to the evaporative emission system at the purge tube until the leak is located using the J 41413-SPT:  White Light.
scientia non olet · About LEMON Manuals