LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2010 >> Camaro LS, Automatic >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 9 (Engine Controls And Fuel - 6.2L - DTC P0315 To DTC P1258) >> DTC P0341 >> Component Testing

Component Testing

WARNING: This page is about a different variant/trim than selected.
NOTE: You must perform the Circuit/System Testing before proceeding with Component Testing.
  1. Inspect the camshaft position sensor for correct installation. Remove the B23 camshaft position sensor from the engine and inspect the sensor O-ring for damage.
    • If the sensor is loose, incorrectly installed, or damaged, replace the B23 camshaft position sensor.
  2. Connect the camshaft position sensor harness connector to the B23 camshaft position sensor.
  3. Ignition ON, observe the Camshaft Position Active Counter parameter with a scan tool.
  4. Pass a flat steel object across the tip of the sensor repeatedly. The Camshaft Position Active Counter parameter should increment with each pass of the steel object.
    • If the function does not perform as specified, replace the B23 camshaft position sensor.
scientia non olet · About LEMON Manuals