Circuit/System Verification

WARNING: This page is about a different variant/trim than selected.

NOTE: Any MIL requesting DTCs that may be set should be diagnosed first.

Ignition ON, command the MIL ON and OFF with a scan tool. The MIL should turn ON and OFF as commanded.
Ignition ON, command the MIL ON and OFF with a scan tool while observing the following control circuit status parameters:
- MIL Control Circuit Low Voltage Test Status
- MIL Control Circuit Open Test Status
- MIL Control Circuit High Voltage Test Status
  Each parameter should toggle between OK and Not Run or Not Run and OK.