Valve Rocker Arm Cover Replacement - Right Side

WARNING: This page is about a different variant/trim than selected.

Fig 1: Valve Rocker Arm Cover - Right Side

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
Preliminary Procedures Remove the crankcase ventilation hoses/pipes. Refer to Positive Crankcase Ventilation Hose/Pipe/Tube Replacement . Remove the ignition coil. Refer to Ignition Coil Replacement .
1	Valve Rocker Arm Cover Fastener (Qty: 4) CAUTION: Refer to Component Fastener Tightening Caution . Procedure: If valve rocker arm cover grommets are cracked, or damaged, replace the valve rocker arm cover bolts. The grommet is serviced with the rocker arm cover bolt. Tighten: 12 N.m (106 lb in)
2	Valve Rocker Arm Cover Procedure Disconnect any electrical connectors. Transfer components as necessary.

Callout

Component Name

Preliminary Procedures

Remove the crankcase ventilation hoses/pipes. Refer to Positive Crankcase Ventilation Hose/Pipe/Tube Replacement .
Remove the ignition coil. Refer to Ignition Coil Replacement .

Valve Rocker Arm Cover Fastener (Qty: 4)

CAUTION: Refer to Component Fastener Tightening Caution .

Procedure:
If valve rocker arm cover grommets are cracked, or damaged, replace the valve rocker arm cover bolts. The grommet is serviced with the rocker arm cover bolt.

Tighten: 12 N.m (106 lb in)

Valve Rocker Arm Cover

Procedure

Disconnect any electrical connectors.
Transfer components as necessary.