LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2010 >> Camaro LS, Automatic >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 5 (Engine Mechanical - 6.2L - Repair Instructions - On Vehicle) >> Valve Lifter Replacement (With AFM) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Valve Lifter Guides & Bolts
    GM1402039Courtesy of GENERAL MOTORS CORP.
  1. Remove the cylinder head and gasket. Refer to Cylinder Head Replacement - Left Side 
  2. Remove the cylinder head and gasket. Refer to Cylinder Head Replacement - Right Side .
  3. Remove the valve lifter guide bolts (211).
  4. Remove the valve lifter guides (210) with the lifters. Note the installed position of the guides. The notched area of the guides is to align with the locating tab on the engine block.
    5. Fig 2: Exploded View Of Lifter Guides & Lifters
    GM1402040Courtesy of GENERAL MOTORS CORP.
  5. Remove the valve lifters (209, 219) from the guide (210).
    6. Fig 3: Aligning Notched Area Of Guide With Raised Surface On Side Of Lifter
    GM1402044Courtesy of GENERAL MOTORS CORP.
    NOTE: The active fuel management lifters are installed into the guide by aligning the notched area of the guide (1) with the raised surface on the side of the lifter (2).
  6. Organize or mark the components so that they can be installed in the same location from which they were removed, if required.
  7. Clean and inspect the valve lifters, if required. Refer to Valve Lifter and Guide Cleaning and Inspection
scientia non olet · About LEMON Manuals